Updating the innova 3100c victoria dating com

In 1991, the California Air Resources Board (CARB) instituted new regulations that required every new automobile to have an OBD1 system.These initial systems weren't standardized and each car manufacturer used its own connectors and data link protocol.The large 7-inch touchscreen makes it easy to read and allows for user-friendly navigation.in your car to display vital information about how your car is operating.Next, you will have to enter your vehicle's information, which may include the make and model, VIN number, and engine type.Each scanner will require different information depending on the device model and manufacturer.

When users buy our independently chosen editorial picks, we may earn commissions to support our work.

It is a somewhat triangular 16-pin connector that looks similar to old computer monitor and printer ports.

It is most often located underneath the left hand side of the dashboard near the steering column.

Once found, you insert the OBD2 scanner connector, this can either be a cable attached to the scanner or a separate device that wirelessly sends the information, so it can initiate communications with your on-board computers.

You will then see some kind of message like "establishing data link" or "searching for protocol." If your screen does not light up with some kind of message, you device has not made a connection and you should try jiggling the connector or unplugging it and plugging it back in.

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “updating the innova 3100c”